The APM 2.5/6 Power Module is a simple way of providing your APM 2.5/6 with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The on-board switching regulator outputs 5.3V and a maximum of 2.25A from up to a 6S LiPo battery. The Power Module comes completely assembled with XT60 black connectors and wrapped in shrink tubing for protection.
Note: The Power Module is only designed to power APM, a RC receiver and APM accessories (GPS, 3DR radio). It is not designed to power servos. Use your aircraft’s own ESC/BEC for that.
Specifications
• Max input voltage: 28V
• Max current sensing: 90A
• Voltage and current measurement configured for 5V ADC
• Switching regulator outputs 5.3V and 3A max
• 6-pos DF13 cable plugs directly to APM 2.5’s ‘PM’ connector
• Support 6S battery
medicineman1987
20-09-2015
Is this compatible with the PixHawk?
Yes Dr. Aneesh it does 🙂
getsammy
13-01-2016
I purchase this module from you. So far it is working well.
Can I also use this power module to measure voltage an current? That is connecting the voltage from power module to analog input pin 13 and current from power module to analog input pin 12.
You can use it with APM but i am not sure about how you can use it without APM.
rahaanirban91
20-11-2016
does it work with APM mini 3.1?