Axis: 3 axis gyro
Flight controller: Storm32
Motor : 2 pcs 2204 260kv & 1 pc 2805 140kv
Battery plug: JST
Weight: about 177.5 g
Compatible camera: Gopro 4,3,2 ,1 camera/SJ4000( not included)
compatible frame : DJI Phantom 1 2 / Walkera X350
Strom32 Gimbal Controller
board color: blue
motor drivers in DFN packages: yes
on-board MPU: yes
on-board bluetooth module: no
I2C plug type: picoblade (1.25mm JST)
I2C#2 plug type: picoblade (1.25mm JST)
pin headers: no
cable with connectors for MPU module
Points to note:
Firmware : 051
The pins on connector I2C#2 are reversed as with respect to connector I2C
ALL boards HAVE the diode required for running a bluetooth module!!!
supply voltage: 3S battery
motor current: max. 1.5 A per motor
Comment: This is not yet fully exploited, motors with resistances of 12 Ohm or , motors with 10 Ohm may be handled with care.
board dimensions: 50 mm x 50 mm, 45 mm bolt to bolt, holes Ø3 mm
1. Recommended power supply is 12V(3s battery);
2, Camera must be fixed in the head (without any loosening);
3. Adjust the Gopro camera to the left or right, so that the camera is at Horizontal level;
4. Do not power gimbal until the camera is fixed perfectly.
5. The gimbal camera must be use belt tight, otherwise it will have problems. And if you do this many times, it will cause damage to the flight controller.
1 x Aluminum gimbal installed 3 motors(assembled)
1 x Gimbal controller
1 x Sensor
Wiring (camera not included)
Can we control roll, pitch, yaw externally with PWM? Also what are the controllable and rotatory angles of each motoR??
iz it in stock??